Sanalda.comBETA

How is a bank's provision coverage ratio calculated?

Added: 4 November 2026

A bank's provision coverage ratio compares specific provisions recognised for non-performing loans with the gross amount of those loans. In the BRSA sector chart, the indicator is presented for banks applying TFRS 9 as Stage 3 specific provisions divided by non-performing loans. The simple formula is specific provisions divided by gross non-performing loans, multiplied by 100. If gross non-performing loans are 100 billion lira and related specific provisions are 76 billion, the simplified coverage ratio is 76 percent. This is not a figure for a real bank or a current sector value. The ratio describes the size of the recognised loss allowance relative to the troubled-loan stock; it is not a collection guarantee, a definitive measurement of the remaining loss or a complete account of the bank's credit risk. Collateral values, expected recoveries, loan sales, write-offs, restructurings and movements into or out of Stage 3 can change numerator and denominator differently. Writing off a loan may reduce both the gross stock and its related provision, so an increase in the ratio does not always mean that new provisions were booked. Strong collateral also does not remove the need to consider whether and when it can be realised, along with costs and the time value of money. The Basel principles for problem assets and provisions emphasise classification, realistic repayment and recovery expectations, independent validation and collateral measured at net realisable value. Provision coverage is different from total provisions divided by total loans, non-performing loans net of provisions divided by capital, or the non-performing loan ratio. A valid comparison uses the same Stage 3 or non-performing definition, gross exposure basis, consolidation scope and reporting date. It should be read with the portfolio's sector distribution, collateral structure, delinquency age, recovery performance, capital and earnings. A high percentage alone does not prove that a bank is safe, and a lower percentage does not by itself establish inadequate provisioning. The measure is a focused lens on recognised loss absorption for already troubled exposures, not a substitute for the rest of credit-risk analysis.

Formula, scope and a numerical illustration

1. Which troubled exposures form the denominator? The denominator is the gross stock of non-performing or Stage 3 loans within the selected reporting scope. Gross means before deducting the related specific provisions. Classification into Stage 3 depends not only on days past due but also on whether full repayment is likely and on the borrower's financial condition. Solo and consolidated stocks may differ. Loans sold, collected, restructured or written off alter the stock during the period. An analyst should therefore review inflows, cures, collections, sales and write-offs rather than relying only on a closing total. Institutions can be compared only when they use a compatible non-performing definition and perimeter; otherwise the percentage can reflect classification practice instead of loss absorption. 2. What does the specific provision in the numerator represent? The numerator is the allowance recognised in the financial statements for non-performing or Stage 3 exposures. It reflects expected cash flows, recovery timing, the borrower's situation, collateral and reasonable forward-looking information used to measure credit loss. It is not money placed in a separate cash account and it is not a final statement of the amount that will be lost. Adding general expected-loss allowances for Stage 1 and Stage 2 loans to the Stage 3 numerator would not reproduce the ratio shown in the BRSA chart. Collateral's face value is also not simply subtracted from the provision: realisable value, expenses, legal process and timing all matter. 3. A simplified calculation and movement example Assume gross non-performing loans of 100 billion lira and Stage 3 specific provisions of 76 billion. The coverage ratio is 76 divided by 100 times 100, or 76 percent. In the next period, suppose 10 billion of fully provisioned loans is written off and nothing else changes. Gross non-performing loans fall to 90 billion and provisions to 66 billion, so the ratio becomes about 73.3 percent. If the bank then recognises 4 billion of additional provisions on the remaining portfolio, the numerator becomes 70 billion and coverage rises to about 77.8 percent. The example shows that write-offs, loan sales and recoveries matter alongside provision expense. Real reports also require reconciliation of currency translation, purchased portfolios, collateral, accrued interest and consolidation differences.

Movements in the ratio, comparison and limitations

4. Why can the ratio rise or fall? New provision recognition can increase the numerator and lift the ratio when the denominator is unchanged. A new inflow into non-performing status may lower the ratio if its initial allowance is less than its gross carrying amount. Writing off heavily provisioned exposures reduces both numerator and denominator; the direction depends on the coverage of loans that remain. Recoveries can affect the exposure and allowance, while changes in collateral value, expected cash flows or macroeconomic scenarios can alter measurement. Loan sales and restructurings also influence classification. A percentage-point change is therefore not synonymous with provision expense. The movement schedule and the provisioning policy are needed before assigning a cause to two closing ratios. 5. How should banks be compared? Use the same reporting date, currency, solo or consolidated scope and non-performing definition. Consumer, commercial and project-finance portfolios have different recovery patterns, while collateral type affects both timing and uncertainty. Two banks with the same coverage can face different outcomes if one has readily realisable collateral and the other depends on lengthy legal processes. Delinquency age and sector concentration also matter. A BRSA sector aggregate provides a reference, not a description of every institution. Coverage should be evaluated together with non-performing loans to total loans, net problem exposure, restructurings, provision expense, collections, capital and profit. 6. What does the indicator not prove? Provision coverage shows the relative size of the financial-statement buffer recognised against troubled loans; it does not fix future recoveries or final losses. Coverage near 100 percent does not mean that nothing will be collected, while a lower figure is not evidence of a shortfall without considering collateral and expected cash flows. Provision models contain assumptions, data limitations and management judgment. Basel guidance stresses timely classification, realistic repayment expectations and independent review. This ratio does not measure deposit liquidity, interest-rate risk or capital adequacy. Educational analysis must be checked against current BRSA disclosures and the bank's audited notes, and it should not serve as a stand-alone safety judgment or investment decision.

Related topics

What is a limit order?What is a current account deficit?How is the outstanding claims provision calculated?How is retirement age calculated?What is a debt-instruments fund?How is the price of a 22-karat gold bracelet calculated?How do economies of scale affect a firm?What does an effective exchange rate mean?How does quantitative easing affect financial conditions?What is Bitcoin?Why do equal markup and discount rates not cancel out?How is a fuel price calculated?What is a leading economic indicator?What does a soft landing mean in economics?How should core inflation be interpreted?How does a price floor change supply and demand?How is the cost of a vehicle loan calculated?What is the relationship between risk and return?How is a restructured credit-card installment calculated?What does debt restructuring mean?What is bank liquidity risk?How is an early-loan-repayment charge calculated?How is the break-even point calculated?What is stagflation?Why can unit cost fall as production expands?What is an effective annual cost rate?How is an IBAN validated?What is the difference between gold bullion and gram gold?What is a credit rating?How is the retail sales volume index calculated?
Revision history

4 November 2026 — Article added.